multivac P200 - Setting the Times; Packing Products

Operation
Switching off the machine
03.06.2014 43
¾ Close the stop-cock for the gas supply, if part of the machine.
¾ If required disconnect the machine from the mains electricity.
4.4 Setting the times
¾ Press the key for the desired function.
– The icon of the function flashes in the display.
¾ To set the evacuation time, press the <Evacuation> key.
¾ To set the gas flushing time, press the <Gas flushing> key.
¾ To set the sealing time, press the <Sealing> key.
¾ Using the <arrow> keys, set the desired value.
– The value is adopted.
¾ To change the value slowly, press the <arrow key> briefly.
¾ To change the value quickly, hold the <arrow key> pressed
down.
Info
If the value for the gas flushing time or sealing time is set to 0, the
function is switched off and the symbol of the function is not shown
in the display.
Info
With effect from software version 2.3, the evacuation time changes
as of 60 s from a display in seconds to a display in minutes. With
effect from one minute, the evacuation time can only be set in
tenths of a second.
¾ Press the key of the function again.
– The icon of the function is shown continuously in the display.
4.5 Packing products
¾ Open the chamber lid. Open the chamber lid more than half way
so that it remains open.
– The chamber lid remains open in the middle position.