Maintenance
Change the oil in the vacuum pump
70 03.06.2014
Info
Only use low odour synthetic oil if food is being packed.
¾ Check the oil level on the oil sight glass.
– The oil level is then approximately in the middle of the oil sight
glass.
¾ Turn the screw plug in the fill opening and screw it tight. Turn the
screw plug clockwise.
¾ Wipe off and remove any oil
¾ Close housing, see Section 7.5 "OPEN AND CLOSE THE HOUSING".
¾ Connect the machine to the mains electricity.
¾ Switch on the machine.
¾ Check the oil level after a couple of machine cycles.
To Next Page
Loading...
