Page11of41
IMC01 Banknote Counter User Manual
Version 1.06
4.0. Operating Instructions
4.1. Start-up
Turn on the switch after connecting the machine to power supply. First, the machine enters the self-checking
interface, as shown in Figure 4-1.
Figure 4-1 Self-checking Interface
Please wait patiently for about 20 seconds, and the machine will spin the banknote processing wheel several
times to conduct a self-check, and then enter the main interface as shown in Figure 4-2.
Figure 4-2 Counting Ready State Interface
4.2. Selection of Counting Mode
4.2.1. Single Currency Counting Mode
After the machine is turned on, the flag & currency graphic appears in the upper left corner, indicating that the
machine is in the current currency counting mode.
The default mode is MDC mode. By pressing the key of the control panel, three counting modes can be
cyclically switched, and the 3 counting modes will be cyclically switched according to MDC-CNT-SDC
sequence.
4.2.1.1. MDC Mode
As shown in Figure 4-3, the IMC01 is in MDC mode. In this mode, the IMC01 will count the banknotes of all
denominations of the selected currency, and save the detail information of the counted banknotes at the same
time, including the total amount and the total number of the banknotes in stacker, so as to facilitate users to
check. In this mode, the IMC01 has 2 counting speed (800/1000 pcs/min) options.
To Next Page
Loading...
