MUNBYN IMC01 - Counting Speed Setting; Check Detail of Counting; Check the Serial Number

Page18of41
IMC01 Banknote Counter User Manual
Version 1.06
4.4. Counting Speed Setting
There are four counting speed options: 1500, 1200, 1000 and 800 (Note: 1500 and 1200 are the only optional in
CNT mode). The default speed is 1000 in three modes. If setting is required, different counting speed can be
switched by pressing the key in any counting mode.
Figure 4-20 IMC01 Speed Indicator
4.5. Check Detail of Counting
In the MDC or SDC mode, press the key upon the completion of counting to enter the interface shown
in the following figure to check the details of counting.
Figure 4-21 Detail Denomination Information
4.5.1. Check the Serial Number
As shown in Figure 4-21, if the SN reading is on, press the key again, the banknote’s serial number will
be shown in the following figure.