Introduction
User manual 55530_hdb_en_16 7 / 156
1.3 About this manual
Scope This document describes the use of the devices:
Hardware / Firmware
Information This document contains information on
fitting and electrical installation
startup and parameterization
circuit examples
fault diagnosis and troubleshooting
conformity and approval
Read this chapter carefully before you start working with the documenta-
tion or the device.
Read the documentation carefully before starting up the device.
Store the manual in a place that is accessible to all users at all times for
the entire service life of the device.
You will need general knowledge about automation engineering in order to un-
derstand this manual. In addition, planning and using automation systems re-
quires technical knowledge which is not contained in this manual.
Software
Purpose of this
document
This document instructs the technical staff of the machine manufacturer or
machine operator on the safe use of the devices described in the
"Scope of Application".
It does not include instructions on the safe use of the machine in which the
devices are integrated. For information about this, refer to the operating man-
ual of the machine.
Further applicable doc-
uments
Name Art.-No.
MVK-MPNIO DIO16 IRT 55530
MVK-MPNIO DIO14 IOL2 IRT 55531
MVK-MPNIO DIO12 IOL4 IRT 55532
Version
Hardware (HW) Firmware (FW)
2.0 1.10 and higher
Software used
Totally Integrated Automation (TIA) Portal V15 by Siemens AG
Murrelektronik IO-Link Device Tool 4.0.30
Document Art.-No. Location
Operating instructions 55530
55531
55532
Included in the scope of delivery or down-
loadable from
http://shop.murrelektronik.com
Bus manual www.profibus.com
PROFINET
PROFIenergy
www.profibus.com
IO-Link http://www.io-link.com
To Next Page
Loading...
Need help?
General
