38 Setting auto cut
2 Advanced settings
Settings in this product can be changed to match your usage.
Only a part of functions is introduced here.
For usage functions of software, please refer to help or manual of software.
"Displaying Help or Manual" on page 11
It can be set to cut media automatically, when printing is done.
Setup is done to match the width, thickness and material of media.
Setting auto cut
Note
Depending on media, cutting cannot be done. In such a case, cut manually.
Steps
[1]
Launch the remote panel of VSM.
"Displaying remote panel" on page 9
[2]
Select anything but [Off] in the [Media Initial] menu under the [Media Setting] tab.
[3]
Select [Auto Cut] in the [Output Mode] menu under the [Advanced Setting] tab.
Advanced settings
To Next Page
Loading...
Need help?
General