Cutting by hand 39
For media that cannot be cut with the built-in cutter in the product, please cut following the next steps.
In this product, a setup is possible to cut media automatically after printing is done. Refer to the setup methods described
below.
"Setting auto cut" on page 44
Cutting by hand
[1]
Check printing is done.
[2]
Feed the media to a position where print results can be cut.
"Forwarding/Rewinding media" on page 37
[3]
Open the front cover, and cut the media with a commercial available cutter.
• Cut along the media cut groove.
[4]
Close the front cover.
Cutting automatically
To Next Page
Loading...
