71
Batteries
Batteries
Your MyStar Extra® Meter comes with two pre-installed, CR2032 3 volt,
lithium batteries. Battery #1 powers the backlight and battery #2
powers the basic meter functions. When the power from battery #2
is low or the battery is dead, the low battery icon or dead battery
icon will be displayed on the screen until you change battery #2.
When replacing battery #2, the time and date information may be
lost after the battery is removed from the meter. If this happens,
activate the meter after installing the new battery and it will prompt
you to set the time and date. Correct time and date settings are
needed to get correct blood glucose averages. Removing the
batteries does not a ect the meter memory.
CAUTION: When the low battery icon appears, you should replace
the batteries immediately. Use only CR2032 batteries.
Note: Dispose of used batteries according to your local environmental
regulations. Your meter is also an electronic device. When disposing of
your meter, follow all local environmental regulations.
CHAPTER
12
To Next Page
Loading...
