56
nal von minden GmbH · Manual
Reac f Touch
Press
to run a Level 2 test if you set the control number to 2 or 3. (For further
instruc ons on how to set QC test levels, refer to Sec on 7 Analyzer Setup: Lockout: QC
Lockout). The test steps are the same as those for Level 1.
When both QC Tests pass, the “E” at the end of the test number will not be shown and
the test mode will change back to Rou ne.
If you set the control number to 3, the Level 3 test will be run, in which the steps are the
same as those for Level 1.
To Next Page
Loading...