EN
W415-2005 / A / 06.26.19
25
6.0 operating instructions
Once the appliance has been plugged into a grounded electrical outlet or hard-wired
to a dedicated 120V power supply, it is ready to operate.
6.1 operating touch display panel and remote control
The touch display panel is shown by LED's on the bottom right corner of the appliance. The LED's will
disappear after 3 seconds of no function change. The Main Power button will disappear.
Ensure the house circuit breakers for the power supply are turned on. In the event of a power failure, the
appliance will lose its memory function and will reset to factory mode when the power returns.
note:
• Do not move or remove the glass panel, when the appliance is plugged in and operating. This will cause the
remote control and touch panel to no longer function.
!
WARNING
Control Panel
Remote Control
To Next Page
Loading...
Need help?
General
