14-18 Remote control
SSDT b
This setting command sets the detector for Sweep Mode. The argument (b) should
be a character representing the detetector as follows:
o P Peak
o Q QuasiPeak
o A Avg
o R Rms
o N C-Rms
o C C-Avg
Optionally, the character ‘S’ may precede to activate the Smart Mode detector. Thus,
if Smart Qpeak is desired the command should be #SSDT SQ*
The reply is SSDT =OK which acknowledges the command has been granted or
SSDT =SERR if the command has been ignored.
Example 1: # SSDT P* sets the detector to Peak for Sweep Mode
Example 2: # SSDT SA* sets the detector to Smart Average for Sweep Mode
To Next Page
Loading...
