Index
© National Instruments Corporation I-5 NI 8352/8353 User Manual
Hardware Monitor Logic, 2-17
help, technical support, D-1
Hyperthreading, 2-12
I
I/O Device Configuration, 2-14
ICH RAID Code Base, 2-5
IDE connector location (figure), B-20
IDE controller, using SCSI hard drive in
addition, 4-1
IDE Primary Master/Slave, 2-5
IDE Secondary Master/Slave, 2-5
IDE1 connector, B-21
IDE1 connector (figure), B-21
inner slides, installing (figure), 2-23
inner slides, installing into outer slides
(figure), 2-26
installation, 2-2
configuration and operation
connecting safety ground, 2-3
site considerations, 2-2
testing power up, 2-3
unpacking the NI 8352/8353, 1-1
configuration in MAX (figure), 4-3
installing a PCI Express expansion card, B-23
installing an operating system, 2-28
installing hard disk drives, B-22
installing NI 8352/8353, 2-1
instrument drivers (NI resources), D-1
Intel Matrix Storage Manager utility,
exiting, C-4
Intel RAID Configuration utility, C-1
creating volumes
RAID0, C-1
RAID1, C-2
RAID10, C-2
RAID5 set, C-3
deleting a RAID volume, C-4
exiting Intel Matrix Storage Manager
utility, C-4
resetting a RAID HDD, C-4
resetting to non-RAID, C-4
Intel SATA RAID utility for Intel ICH7R, C-1
Intel Virtualization Technology, 2-13
Interrupt, 2-14, 2-15
IPMI, 2-18
IPMI Specification Version, 2-18
J
jumper locations (figure), B-3
jumper settings, B-3
clear CMOS jumper (JBT1), B-5
CompactFlash master/slave connector
(JP3), B-5
GLAN1/GLAN2 (JPL1/JPL2), B-4
Power Force On (JPF), B-6
SMBus to PCI/PCI-Express slots
(JI
2
C1/JI
2
C2), B-4
VGA connector (JPG1), B-4
watchdog (JWD), B-6
K
KBC Clock Input, 2-14
key features, 1-2
keyboard, overview (table), 3-1
kit contents, 1-1
KnowledgeBase, D-1
L
L3 Cache, 2-12
LabVIEW, 1-7
LabWindows/CVI, 1-7
Large Disk Access Mode, 2-11
Latency Timer, 2-11
LBA Format, 2-6
LBA Mode Control, 2-6
LEDs, front panel, 4-1
Legacy Diskette A, 2-4
To Next Page
Loading...
Need help?
General
