© National Instruments | 3-1
3
Maintenance
This chapter describes basic maintenance procedures you can perform on the PXIe-1095 chassis.
Caution Disconnect all power cables prior to servicing a PXIe-1095 chassis.
Service Interval
Clean dust from the chassis exterior (and interior) as needed, based on the operating
environment. Periodic cleaning increases reliability.
Preparation
The information in this section is designed for use by qualified service personnel. Read the Read
Me First: Safety and Electromagnetic Compatibility document included with your kit before
attempting any procedures in this chapter.
Caution Many components within the chassis are susceptible to static discharge
damage. Service the chassis only in a static-free environment. Observe standard
handling precautions for static-sensitive devices while servicing the chassis. Always
wear a grounded wrist strap or equivalent while servicing the chassis.
Cleaning
Cleaning procedures consist of exterior and interior cleaning of the chassis. Refer to your
module user documentation for information on cleaning the individual CompactPCI or
PXI Express modules.
Caution Always disconnect the AC power cables before cleaning or servicing the
chassis.
Interior Cleaning
Use a dry, low-velocity stream of air to clean the interior of the chassis. Use a soft-bristle brush
for cleaning around components.
To Next Page
Loading...
Need help?
General
