National Instruments SCB-68A - Page 89

Index
I-2 | ni.com
components
adding
attenuating voltage
, 2-37, 3-9, 4-9
current input measurement, 2-33
highpass filtering
, 2-30
lowpass filtering, 2-25, 3-6, 4-6
locations
analog input (table)
, 2-5
analog output (table), 3-2
selecting
attenuating voltage
, 2-36, 3-9, 4-9
current input measurement
, 2-33
highpass filtering, 2-29
lowpass filtering
, 2-24, 3-6, 4-5
connections
analog input signals, 2-5
differential for floating signal
sources
, 2-12
floating signal sources, 2-7
ground-referenced signal sources
, 2-12
single-ended for floating signal
sources, 2-12
single-ended, RSE configuration
, 2-12
conventions used in the manual, v
current input measurement, 2-32
adding components
, 2-33
analog input, 2-33
differential, 2-33
single-ended
, 2-34
selecting a resistor, 2-33
D
Declaration of Conformity
(NI resources), B-1
diagnostic tools (NI resources)
, B-1
differential connections
bias resistors
balanced
, 2-20
single
, 2-20
current input measurement, 2-33
highpass filtering
, 2-30
lowpass filtering
, 2-25
open thermocouple detection, 2-18
using with floating signal sources
, 2-8
using with ground-referenced signal
sources, 2-14
when to use with floating signal
sources, 2-7
when to use with ground-referenced
signal sources
, 2-12
digital inputs
attenuating voltage
, 4-9
circuit diagram (figure), 4-1
lowpass filtering
applications
, 4-7
voltage dividers
, 4-10
digital triggers
circuit diagram (figure)
, 4-1
lowpass filtering
applications, 4-7
documentation
, 1-13
conventions used in the manual, v
NI resources, B-1
drivers (NI resources)
, B-1
E
examples (NI resources), B-1
F
filtering
highpass, 2-27, 4-8
lowpass
, 2-21, 3-2, 4-2
power, 5-2
thermocouple input, 2-19
floating signal sources
connecting
, 2-7
description
, 2-7
using in differential mode
, 2-8
using in NRSE mode, 2-11
using in RSE mode
, 2-12
when to use
in differential mode
, 2-7
in NRSE mode
, 2-7
in RSE mode
, 2-8