National Instruments SCB-68A - Page 90

NI SCB-68A User Manual
© National Instruments | I-3
G
ground-referenced signal sources
connecting, 2-12
description, 2-12
using in differential mode
, 2-14
using in NRSE mode, 2-15
when to use in differential mode, 2-12
when to use in NRSE mode
, 2-13
when to use in RSE mode, 2-13
H
help, technical support, B-1
highpass filtering, 2-27, 4-8
analog input, 2-30
applications
, 2-31
differential, 2-30
single-ended, 2-30
components
adding
, 2-30
selecting, 2-29
one-pole highpass RC filter
, 2-29
I
installing bias resistors, 2-20
instrument drivers (NI resources)
, B-1
K
KnowledgeBase, B-1
L
lowpass filtering, 2-21, 3-2, 4-2
analog input
, 2-25
differential
, 2-25
single-ended, 2-25
analog output
, 3-6
applications
analog input
, 2-26
analog output
, 3-7
digital inputs
, 4-7
digital triggers, 4-7
PFI 0
, 4-7
components
adding for analog input, 2-25
adding for analog output, 3-6
adding for digital filtering, 4-6
selecting
, 2-24, 3-6, 4-5
one-pole lowpass RC filter, 2-24, 3-5,
4-5
M
measurement
current input
analog input
, 2-32
analog output
, 3-8
digital input, 4-8
N
National Instruments support and
services, B-1
non-referenced single-ended connections
using with floating signal sources
, 2-11
using with ground-referenced signal
sources
, 2-15
when to use with floating signal
sources, 2-7
when to use with ground-referenced
signal sources
, 2-13
O
one-pole
highpass RC filter, 2-29
lowpass RC filter
analog input
, 2-24
analog output, 3-5
digital trigger
, 4-5
open thermocouple detection
, 2-18
sources of error, 2-19
P
PFI 0, 4-1
attenuating voltage, 4-9
circuit diagram (figure)
, 4-1
lowpass filtering applications
, 4-7