Index
I-4 | ni.com
power filters, 5-2
printed circuit board diagram (figure)
, 1-4
programming examples (NI resources), B-1
R
referenced single-ended connections
using with floating signal sources, 2-12
when to use with floating signal
sources
, 2-8
when to use with ground-referenced
signal sources, 2-13
related documentation
, 1-13
removing the SCB-68 board from the
base
, 1-11
S
signals
connecting analog input, 2-5
floating sources
, 2-7
ground-referenced, 2-12
single bias resistor, 2-20
single-ended connections
attenuating voltage
, 2-37
current input measurement, 2-34
for floating signal sources
, 2-12
highpass filtering, 2-30
lowpass filtering, 2-25
open thermocouple detection
, 2-19
RSE configuration, 2-12
when to use non-referenced single-ended
connections with floating signal
sources
, 2-7
when to use referenced single-ended
connections with floating signal
sources
, 2-8
software (NI resources)
, B-1
soldering and desoldering
equipment
, 1-11
guidelines
, 1-12
sources of error, open thermocouple
detection
, 2-19
specifications
, A-1
support, technical
, B-1
T
technical support, B-1
temperature sensor
accuracy, 2-17
output
, 2-17
thermocouples, 2-21, 4-2
input filtering, 2-19
open thermocouple detection
, 2-18
differential analog input, 2-18
single-ended analog input, 2-19
sources of error
, 2-19
temperature sensor output and
accuracy
, 2-17
training and certification (NI resources)
, B-1
troubleshooting (NI resources), B-1
V
voltage attenuation
analog input, 2-35
analog output, 3-8
digital input
, 4-8
voltage dividers, 3-10
voltage dividers, 3-10
analog input
, 2-38
analog output, 3-10
digital inputs, 4-10
W
Web resources, B-1
To Previous Page
Loading...
