68
Appendix
Required Tools
This is a list of the most common tools you will need to service the E916 and EV916 Ellipticals.
Table A–1. Required Tools and Uses
Tool Purposes
Socket wrench General
3/4" socket (deep well) Removing and installing misalignment nut
3/4" open-end box wrench Removing and installing nut on swing arm and foot link assembly
1/4" Allen wrench Hex cap screws on crank arms
9/16" wrench Adjusting belt tension
9/16" Allen wrench Removing and installing screws on crank cover
7/16" Allen wrench Adjusting belt tension
#2 Philips screwdriver Removing and installing screws on pod and drivetrain covers
Snap Ring Pliers Connecting arm and eccentric crank arm
Tape Measure Adjusting belt tension
Diagonal cutters
General
Multimeter Electrical troubleshooting
International Power Plug Configurations
Table B–1. International Power Plugs
Power Cords System Country
G UK
C, E, F Europe
J Swiss
K Australia
L
To Next Page
Loading...
