Navman Tracker 5607 - 2-2 Using the menus; 2-3 Turning on and off; auto power

NAVMAN TRACKER 5507/5607 Installation and Operation Manual
12
Operate the 5507/5607 by selecting items from
menus. Items can be submenus, commands or
data.
Selecting a submenu
A after a menu item indicates a submenu, for
example
Chart . Press or to move the
highlight to the submenu, then press
.
Starting a command
Press
or to move the highlight to the
command, for example Goto cursor, then press
.
Changing data
First press
or to move the highlight to the
data to change, then:
a) To change a tick box
means On or Yes
means Off or No.
Press or to change the tick box.
b) To select an option
1 Press
to display the menu of options.
2 Press
or to move the highlight to the
option you want, then press
.
2-3 Turning on and off / auto power
Turning on manually
If the 5507/5607 is not wired for auto power, press
to turn the unit on. If necessary, adjust the
display to be easy to read (see section 2-4).
Note: If the 5507/5607 is not wired for auto power
then the 5507/5607 does not record engine hours
and might not record fuel consumption (see
section 16-4).
Turning off manually
If the 5507/5607 is not wired for auto power or if
the ignition switch is off, hold down
until the
display turns off.
Auto power
If the 5507/5607 is wired for auto power (see
section 16-4), then:
The 5507/5607 automatically turns on when
you turn the boat’s ignition switch on.
You can not turn the 5507/5607 off while the
ignition switch is on.
If Auto power off (see section 15-1)
is , the 5507/5607 automatically turns off
when you turn the boat’s ignition switch off.
If Auto power off (see section 15-1)
is
, the 5507/5607 stays on when you turn
the boat’s ignition switch off. You can now
turn the 5507/5607 off manually.
2-2 Using the menus
c) To change a name or number:
1 Press
to display the name or number:
2 Press or to select a letter or digit to
change. Press
or to change the letter or
digit.
Repeat this to change other letters or
numbers.
3 Press
to accept the new value. Or press
to ignore the changes.
d) To change a slider value
Press
to decrease the value or to increase
the value.