BIOS Updating Procedure 5-55
Using the Unattended Windows Flash method
This method requires no user input to initiate the flash.
1. Open a Command Prompt window and navigate to the directory where the
windows executable is located.
2. Type in the name of the file followed by /reboot.
Example: Flash_PX10_1091.exe /reboot
The BIOS will automatically begin updating.
3. The BIOSwill reboot upon completion. The reboot is important to ensure the BIOS
initializes properly. Do not interrupt the reboot process.
Note: After the update has completed and the terminal is rebooted, the terminal
may reboot additional times as it powers up. This is normal and expected behavior
due to the nature of the features of the BIOS/SPI.
To Next Page
Loading...
