NCR RealPOS 40 - Page 79

Chapter 3: Setup 3-3
DMAMode [Auto]
S.M.A.R.T. [Auto]
32BitDataTransfer [Enabled]
SuperIO Configuration

 SerialPortA/1Address [3F8]
SerialPortA/1IRQ [4]
 SerialPortB/2Address [2F8]
SerialPortB/2IRQ [3]
 SerialPortC/3Address [3E8]
 SerialPortC/3IRQ [11]
 SerialPortD/4Address [2E8]
 SerialPortD/4IRQ [10]
System Hardware Health Monitoring
Typical(AcceptableRange)
 CPUTemperature :51°C/125°F (less than 65°C)
 GMCHTemperature :50°C/122°F (less than 65°C)
 VRMTemperature :49°C/120°F (less than 60°C)
 Fan1Speed :N/A(no fan)
 Fan1Speed :N/A
 CPUVcore :1.184V(1.00 – 1.30)
 CPUVIT :1.056V(0.90 – 1.20)
 +3.30V :3.312V(3.05 – 3.55)
 +5.00V :4.972V(4.60 – 5.40)
 +12.0V :11.904V(11.20 – 12.80)
 5Vsb :4.945V(4.60 – 5.40)
ACPI/APM Configuration

 ACPIAwareO/S [Yes]
 Suspendmode [S3(STR)]
 USBDeviceWakeupFromS4 [Enabled]
 PowerButtonMode [On/Off]
 RestoreonACPowerLoss [LastState]