NCR RealPOS 40 - Chapter 5: BIOS Updating Procedures; Introduction; Prerequisites

5
Chapter 5: BIOS Updating Procedures
Introduction
ThischapterdiscussesproceduresonhowtoupdatetheterminalBIOS.Thesoftware
isdistributedviatheNCRWebsite.
BIOSupdatingcanbeperformedusingthefollowingmethods:
 BootableUSBCDDrive
 BootableUSBMemoryDrive
 Network–RefertotheNCRFitClientSoftwareUserʹsGuide,(B005‐000
0‐1235)for
informationaboutthisprocedure.
Prerequisites
ThefollowingarerequiredtoperformaBIOSupdate.
 BootableUSBCD‐ROMDrive
 Keyboard
 BIOSSoftware.DownloadfromtheNCRwebsite:
http://www.ncr.com
a. Atthissite,selecttheSupporttab.
b. SelectDrivers and Patches→Retail Support Files→NCR RealPOS and
SelfServ Terminal and Operating Systems→NCR RealPOS 40 (7600)→
BIOS.
c. SelectthedesiredBIOSFile.
 ISOImage–UsedwithCDROMbootdevice
 DiskImage–UsedwithFloppyDiskbootdevice
 NetworkImage–UsedwithNetworkboot
 USBMemoryKeyImage–UsedwithUSBbootdev
ice
d. Savethesoftwaretoyourlocalharddrive.