Chapter 10: BIOS Setup
Entering Setup
1. Connect an alphanumeric USB keyboard to the terminal.
2. Apply power to the terminal.
3. When you see the NCR logo displayed press [Del].
How to Select Menu Options
The following keyboard controls are used to select the various menu options and to
make changes to their values.
• Use the arrow keys to select (highlight) options and menu screens.
• Use the [Enter] key to select a submenu.
• Use the [+] and [-] keys to change field values.
• To view help information on the possible selections for the highlighted item, press
[F1].
• To save the changes, move the cursor to the Exit Menu, select either Save Changes &
Exit or Save Changes, and press [Enter].
Restoring Factory Settings
To reset all values to their default settings for the current screen, press [F9]. The
terminal automatically loads the BIOS default values. To reset all BIOS settings to their
default settings go to the Exit menu, press [F9], select either Save Changes & Exit or Save
Changes, and press [Enter].
See the BIOS Default Settings sections later in this chapter for the pre-installed Setup
defaults.
Disabling Resources
Resources that are disabled in the BIOS (IRQs for COM ports/on-board LAN/secondary
IDE) are still detected and installed (sometimes partially) in Windows. The resources are
actually available.
To Next Page
Loading...
