4-66 Touch Screen Calibration
Installing the Driver
Note: If you have a previous version of another touch screen driver loaded on your
system you must completely remove it using the Control Panel Add/Remove program
before continuing with this installation process.
1. Extract the driver installation files into to a working directory on the POS terminal.
2. Run the Setup.exe program from this directory.
3. Welcome screen. Select Next
4. License Agreement screen. Select Accept→Next
5. Use the USB Controller Interface. Select Next.
6. Setup is ready to install. Select Next→Finish
At the completion of the install program the driver is loaded and functioning. You do
not have to restart your system.
To Next Page
Loading...
