Chapter 11: BIOS Updating Procedure
Introduction
The BIOS is located in the Serial Peripheral Interface (SPI) chip on the processor board.
This chapter discusses procedures on how to update the terminal SPI and/or BIOS. The
update software is distributed via the NCR Website.
The BIOS update can be performed using the following methods:
• Bootable USB Memory Device
• Network - Refer to the NCR Retail Systems Manager (RSM) Software User's Guide,
(B005-0000-1518) for information about this procedure.
Prerequisites
The following are required to perform a SPI/BIOS update.
• USB Keyboard
• BIOS Software. Download from the NCR website:
http://www.ncr.com
1. At this site, select the Support tab.
2. Select Drivers and Patches → Retail Support Files → NCR RealPOS and
SelfServ Terminal and Operating Systems →
NCR RealPOS 72XRT (7616) → BIOS.
3. Select the desired BIOS File.
• Network Image - Used with Network boot
• USB Memory Key Image - Used with USB boot device
4. Save the software to your local hard drive.
To Next Page
Loading...
