11-156 BIOS Updating Procedure
3. The Manageability Engine (ME) is programmed and a message is displayed
indicating power must be removed before continuing. Press [3] to perform a 20
second AC power removal (automatically executes in 10 seconds if no keys are
pressed).
4. Remove the USB device before the system boots.
5. System is ready for operation.
Option 2 - Update BIOS only - No prompt for Serial/Model/Class unless invalid
This option automatically updates the BIOS only.
1. Highlight Option 2 and press [ENTER].
2. The Flash Program updates the BIOS and automatically reboots the terminal.
Option 3 - Update DMI only - Serial/Model/Class update ONLY (no BIOS or SPI
Update)
This option lets you enter the DMI information only. The SPI and BIOS are not updated.
1. Highlight Option 3 and press [ENTER].
2. At the prompt press [ENTER] to enter the Class/Model/Serial Number information
(DMI). Follow the onscreen format instructions.
Example: 7616-1500-8801[ENTER]
54-19378230[ENTER]
3. Press [1] to confirm the data and to continue.
4. Remove the USB device before the system boots.
5. System is ready for operation.
Option 4 - Update of SPI and BIOS - Always prompts for Serial/Model/Class
This option is similar to Option 1 above except you are prompted for Class/Model/Serial
information at the beginning of the program. You also have to select which type of
update to run, BIOS or SPI.
1. Highlight Option 4 and press [ENTER].
2. At the prompt press [ENTER] to enter the Class/Model/Serial Number information
(DMI). Follow the on-screen format instructions.
Example: 7616-1500-8801[ENTER]
54-19378230[ENTER]
3. Press 1 to confirm the data and to continue.
4. The Flash Program updates the SPI/BIOS and the Manageability Engine (ME) is
programmed.
To Next Page
Loading...
