NCR RealPOS 72XRT POS - Page 9

ix
Powering Up the Terminal 57
Terminal On/Off Switch 57
Power Button Override 57
Default Boot Order 58
Keyboard support 58
Connecting peripherals 58
Calibrating the Touch Screen 58
Out-of-Box Failures 59
Chapter 3: POST Diagnostics
Diagnostic LEDs 61
Beep Codes 63
Boot Block Beep Codes 63
POST BIOS Beep Codes 63
Chapter 4: Touch Screen Calibration
Introduction 65
Installing the Driver 66
Touch Methods 67
Calibration Procedures 71
Verifying the Calibration 74
Optional Settings 75
Chapter 5: Configuring a Secondary Display
Introduction 77
Setting the Display Mode 78
Intel Graphics Controller Hot Keys 80
Chapter 6: Configuring AMT
Configuring the Terminal 81
Logging onto the Terminal Using AMT 87
Function Definitions 90
Hardware Information 90
Removing the Hard Disks 91
Chapter 7: Installing Optional Remote Peripherals
Introduction 93
Cable Routing 93