NCR RealScan 7875-7000/8000 Installation Guide
06/03 AIP-00342 Release B
12 of 56
Specific Checkstand Modifications
A few checkstands require some modification. Appendices are included for these different types
of checkstands. If modifications are needed, refer to the appendix that matches your installation.
After making any necessary modifications, continue to step 2 on the next page.
• Appendix A – Pan-Oston PO-2
• Appendix B – Pan-Oston PO-3
• Appendix C – Pan-Oston PO-4
Sensormatic Equipment
• Plug the power cord of the Sensormatic ScanMax
TM
Pro into an ac outlet not dedicated to
POS equipment. Plug into an unswitched ac outlet with less than 0.5Vac between neutral
and ground. Electrical Primary input: 100-120/200-240Vac, 50-60 Hz ±5%, 1Arms
maximum.
• Do Not connect through generator or Uninterruptible Power Supply (UPS).
• Keep the power cord and antenna cable away from cash drawers and other items whose
operation may pinch or otherwise damage them. Failure to do so can damage equipment or
injure people nearby.
• Do not plug or unplug ANY Sensormatic ScanMax
TM
Pro Controller cables with power on.
• If mounting the controller to the sidewall of a counter, its cable connectors cannot face up.
• Deactivator Interacting with Other Devices: Isolate ScanMax Pro controller from neon
signs, motors, computers, cash registers, terminals, or data communications equipment.
Computer monitors, TVs, switching power supplies and neon displays can affect deactivator
operation. Keep the Sensormatic ScanMax
TM
NS Pro Antenna away from these devices
whenever possible.
• Environmental: Operating temperature 0 to 40°C (32° to 104°F) / Non-operating
temperature -40° to 70°C (-40° to 158°F)
To Next Page
Loading...
