NCR RealScan 7875-7000/8000 Installation Guide
AIP-00342 Release B 06/03
47 of 56
Appendix A – Pan-Oston PO-2
This checkstand has a metal plate on the left side of the scanner area. This plate must be
removed and replaced with a plastic plate.
1. Remove the Side Plate by removing four screws.
2. Use two bolts to connect the Cover Rail (NCR Part Number 497-0430977) to the Plastic
Side Plate (NCR Part Number 497-0430978).
3. Attach the new Side Plate assembly to the checkstand using the screws previously removed.
4. Install a Sensormatic Power Pad Label on the Plastic Side Plate. Remove the paper backing
and place the label in the middle of the Plastic Side Plate.
5. Go to Step 2 – Connect the Components.
To Next Page
Loading...
