NCR RealScan 7875-7000 - Programming Worksheets; 0 - Communications Protocol; 1 - Good Read Tone

NCR RealScan 7875-7000/8000 Installation Guide
06/03 AIP-00342 Release B
38 of 56
Programming Worksheets
1 0 – Communications Protocol
Protocol
OCIA
NCR Long
IBM
Slot Scanner
OCIA
Non NCR
Dual Cable
OCIA
Single Cable
RS-232
Casio
Dual Cable
OCIA NCR
Dual Cable
IBM
Hand-Held
Bar Code
Reader
0
OCIA
NCR Short
(Datachecker)
IBM 1520
Bar Code
Reader
TEC
Dual Cable
IBM USB
14391
1 2 3 4 5
6 7 A B C D
E 0
NCR (RS-232) USB
1 1 – Good Read Tone
Tone On/Off
A
Off
0
On
Tone
Frequency
(Hertz)
Tone
Volume
Tone
Length
(Milliseconds)
Not-On-File
Tone Volume
When entering Tone Frequency, the adjustment can be
incremented upward by scanning the
Hex B
tag. Each time
you scan the
Hex B
, the tone frequency increases one unit.
Scan the
End
tag or a valid Hex tag to end this mode.
When entering Tone Length, the adjustment can be
incremented upward by scanning the
Hex C
tag. Each time
you scan the
Hex C
tag, the tone length increases one unit.
Scan the
End
tag or a valid Hex tag to end this mode.
When entering Tone Volume, the adjustment can be
incremented upward by scanning the
Hex D
tag. Each time
you scan the
Hex D
tag, the tone length increases one unit.
Scan the
End
tag or a valid Hex tag to end this mode.
When entering Not-On-File Tone Volume, the adjustment can be
incremented upward by scanning the
Hex E
tag. Each time you scan
the
Hex E
tag, the tone length increases one unit.
Scan the
End
tag or a valid Hex tag to end this mode.
B
C
D
B053
1
B
C
D
EE