NCR RealScan 7875-7000 - AIP-00342 Release B 3 of

56 pages

To Previous Page

To Previous Page

Loading...

NCR RealScan 7875-7000/8000 Installation Guide

06/03 AIP-00342 Release B

56 of 56

Copyright © 2003 by NCR Corporation

Table of Contents

Table of Contents3
Contents3
Revision Record5
Obtaining Additional Information5
Obtaining Technical Assistance6
System Components7
- NCR Components7
- Sensormatic Components7
Step 1 - Verify and Prepare the Checkstand8
- Checkstand Cutout - Realscan 7875-7000/80008
- Service Clearance9
- Item Diverter9
- Ventilation Requirements10
- Electrical Wiring to the Checkstand11
- Specific Checkstand Modifications12
- Sensormatic Equipment12
Step 2 - Connect the Components13
- Install Sensormatic Antenna13
- Connect Sensormatic Cables14
- Connect Remaining Components15
- Set the Communications Protocol Switch16
Step 3 - Sensormatic Deactivation Setup17
- Power up the System17
- Specific Function Programming18
Step 4 - Install Realscan 787519
- Install Realscan 787519
- Align the Realscan 7875 to the Checkstand20
Step 5 - Calibrate the Scale22
- Set Scale AC Voltage Frequency22
- Exercise the Scale22
- Access the Calibration Switch23
- Calibrate the Scale24
- Verify the Calibration24
- Decreasing Load Test25
- Secure the Calibration Switch26
Step 6 - Set Program Parameters27
- Setting the Program Parameters27
Step 7 - Check the Scanner Operation28
- Scan Sample Tags28
- Check Sensormatic Deactivation System29
- Call Sensormatic29
Operating the Scanner30
Operating the Scale31
Operating the Sensormatic Deactivation System32
- Normal Operation32
- Manual Deactivation33
Cleaning the Realscan 787534
Correcting Scanner Problems35
Correcting Scale Problems36
Isolating Sensormatic Problems37
- Voice Messages37
- Tones37
Programming Worksheets38
- 0 - Communications Protocol38
- 1 - Good Read Tone38
- 2 - Timers39
- 3 - Bar Codes - 139
- 4 - Bar Codes - 240
- 5 - Bar Codes - 341
- 7 - Bar Codes - 441
- 8 - Bar Codes - 542
- 6 - Label Identifiers42
- 0 - RS-232 Parameters - 143
- 1 - RS-232 Parameters - 243
- 2 - RS-232 Prefix Byte44
- 3 - RS-232 Terminator Byte44
- 4 - RS-232 Communications Options44
- 0 - Scale Parameters45
- 2 - Miscellaneous Parameters45
- 6 - Dual Cable Interface Options45
- ASCII Code Chart46
Appendix A - Pan-Oston PO-247
Appendix B - Pan-Oston PO-248
Appendix C - Pan-Oston PO-449
Appendix D - Regulatory Information50
- Federal Communications Commission (FCC) Radio Frequency Interference Statement50
- Voluntary Control Council for Interference (VCCI) Radio Frequency Interference Statement5050
- Canadian Department of Communications Radio Frequency Interference Statement50
- Scale Regulatory51
- Declaration of Conformity52
- Laser Safety53
  - Iec Class 1 Laser Identification54
  - Laser Power54
- AIP-00342 Release B 3 of56

Related product manuals

Preview: NCR RealScan 7837-3000

NCR RealScan 7837-3000

Preview: NCR 7872 Series

NCR 7872 Series