Section 1: Start-up Programming
1-10 ◆ Section 1: Start-up Programming DS1000/2000 Quick Setup Guide
5. Enter the access option for the selected trunk + VOL Up.
0 = No access
1 = Incoming only
2 = Outgoing only
3 = Full access (both incoming and outgoing)
6. Enter the access option for the next consecutive trunk.
OR
Press
CONF to go back to step 4 and select another trunk.
OR
Press
CONF twice to go back to step 3 and select another extension.
OR
Press
CONF three times to exit program 1803.
To Next Page
Loading...
Need help?
General
