Section 1: Start-up Programming
DS1000/2000 Quick Setup Guide Section 1: Start-up Programming ◆ 1-13
1
(DS1000)
For Analog Voice Mail (such as analog VANGARD and NVM-2e)
1. Enter the programming mode. You see:
2. Enter
9902 + HOLD. You see:
3. Enter
A (2). You see:
4. Press
VOL Up until you select the first (lowest numbered) analog port to which your analog Voice Mail
is connected.
5. Enter
201 + HOLD twice. You see:
6. Press
VOL Up, then repeat step 5 to assign additional Voice Mail stations (202-208) to the remaining
installed Voice Mail ports.
7. Press
CONF to go back to step 3.
OR
Press
CONF twice to exit program 9902.
For Digital VANGARD
Each Digital VANGARD connection is a two-channel device that represents two Voice Mail ports (stations).
In programming, you assign a separate Voice Mail station (201-208) to each channel. The first channel is
called the primary station; the second channel is called the secondary station.
1. Enter the programming mode. You see:
2. Enter
9902 + HOLD. You see:
3. Press
D (3). You see:
4. Press
VOL Up until you select the first (lowest numbered) digital port to which your Digital VAN-
GARD is connected.
5. Enter
201 + HOLD. You see:
6. Press
HOLD again + VOL Up. You see:
7. Enter
202 + HOLD twice. You see:
8. Repeat steps 4-8 to assign Voice Mail stations to the remaining installed Digital VANGARD Voice
Mail ports.
9. Press
CONF to go back to step 3.
OR
Press
CONF twice to exit program 9902.
USER: nnn
ENTER PROGRAM?
9902:STATION CARDS
D-DGTL/A-ANLG/X-DBOX
9902:ANALOG PORTS
PORT:17 STATION:17
9902:SLOT:n:nASTU
PORT:17 STATION:201
USER: nnn
ENTER PROGRAM?
9902:STATION CARDS
D-DGTL/A-ANLG/X-DBOX
9902:STATION CARDS
PORT:01 PRI STA?1
9902:STATION CARDS
STATION ASSIGNED
9902:STATION CARDS
PORT:nn SEC STA?UND
9902:SLOT:n:16DSTU
PORT:nn SEC STA?202
To Next Page
Loading...
Need help?
General
