NEC DSX-40 - Grounding the Cabinet; Attaching the Ground Wire

Grounding the Cabinet
DSX-40 Hardware Manual Installation ◆ 23
Installation
Grounding the Cabinet
Attaching the Ground Wire
To attach the ground wire:
1. Loosen the lug on the cabinet’s ground connection.
2. Run a 12 AWG stranded copper wire from the ground lug to Electrical Service Ground.
3. Firmly retighten the lug loosened in step 1 above.
Figure 4: Attaching the Ground Wire
Important
You must connect your system to Electrical Service Ground.
Important
In case of fire, disconnect the power cord from the AC outlet.
To Electrical
Service Ground
1093097 - 4