Resetting and Initializing the System
DSX-40 Hardware Manual Installation ◆ 45
Installation
Initializing the System
To initialize (cold start) the system:
- This erases all your stored programming and returns the system to its default settings.
1. Turn off the system.
2. Press and hold the Reset Switch on the Main Equipment Cabinet while turning on the system power.
3. When the LED on the cabinet lights blue and then goes out, release the Reset Switch.
• The power LED will flash green, and then “flutter” blue as the system boots.
• After about 45 seconds, the LED will wink off blue continuously and the system will restart with the
default settings.
Figure 27: Initializing the System
1093097 - 19
2, 3
To Next Page
Loading...
