NEC DSX-40 - Wall Mounting a DSS Console Directly on the Wall

Wall Mounting
DSX-40 Hardware Manual Optional Equipment ◆ 61
Optional
Equipment
Wall Mounting a DSS Console Directly on the Wall
To mount the DSS Console directly on the wall:
1. Mount two suitable fasteners (such as #8 sheet metal screws) about 3 15/16” apart vertically.
- Leave the heads exposed about 1/4”.
2. Fold the DSS Console legs into the wall mount position.
3. Make sure the line cord is routed through the lower channel in the base.
4. Fold the two leg supports down flush with the legs.
5. Place the DSS Console on top of the wall plate and slide into place.
6. Plug the line cord into the DSS Console mod jack.
Figure 40: Mounting the DSS Console Directly on the Wall
1093096 - 32
1
2
3
4
4
5
5
6