Resetting and Initializing the System
44 ◆ Installation DSX-40 Hardware Manual
Resetting and Initializing the System
Resetting the System
To reset the system:
1. Briefly press (tap) the Reset Switch on the Main Equipment Cabinet.
• The power LED will flash green, and then “flutter” blue as the system boots.
• After about 45 seconds, the LED will wink off blue continuously and the system will be operational.
• Resetting the system does not erase system programming.
Figure 26: Resetting the System
Important
If the system’s RS-232 connection uses twisted pair cable, before resetting do one of the following:
• Make sure the RS-232 cable is connected at both ends (i.e., PC and CPU).
• If the RS-232 cable is disconnected from the PC, be sure the cable is also disconnected from the CPU.
1093097 - 18
1
To Next Page
Loading...
