NEC DSX-40 - Wall Mounting a Keyset; Wall Mounting a Keyset on a Standard Wall Plate

Wall Mounting
58 ◆ Optional Equipment DSX-40 Hardware Manual
Wall Mounting a Keyset
Wall Mounting a Keyset on a Standard Wall Plate
To mount the telephone on the standard wall plate:
1. Locate and wire a standard wall plate in a convenient location.
2. Fold the telephone legs into the wall mount position.
3. Make sure the handset coil cord is routed through the lower channel in the base.
4. Fold the two leg supports down flush with the legs.
5. Plug a short line cord into the telephone base.
• If required, coil the excess line cord into the cavity as shown.
6. Plug the other end of the short line cord into the wall plate.
7. Place the telephone on top of the wall plate and slide into place.
Figure 37: Mounting the Telephone to a Standard Wall Plate
109 3 0 9 6 - 31
1
2
3
4
4
7
7
5
6