NEC DSX-40 - Removing the Top Panel; Top Panel Removal

Removing the Top Panel
24 ◆ Installation DSX-40 Hardware Manual
Removing the Top Panel
Top Panel Removal
You must remove the top panel in order to install the system battery and Expansion Cards (if required), or to
replace the power supply AC input fuses.
To remove the top panel:
1. Be sure your system’s power cord is unplugged, then unscrew the 2 captive screws that secure the cabinet
top panel to the base.
2. Lift up the top panel as shown below.
3. Remove the top panel.
Figure 5: Removing the Top Panel
1093097 - 5
1
2
3