NEC Express 5800 Series - Preparations for Setup; Prepare NEC Express5800;Ft Series

1. Setup Procedure
Express5800/R320d-E4, R320d-M4 Installation Guide (VMware 5.5)
15
Chapter 1 Installing OS
1.2
Preparations for Setup
Before SETUP, be sure to do the following.
IF YOU DO NOT PREPARE, SETUP CANNOT BE PERFORMED PROPERLY.
1.2.1
Prepare NEC Express5800/ft series
The components shown below are required for setup.
AC inlet
connector A
REAR
AC inlet
connector B
CPU/IO module 0
System POWER LED
POWER switch
CPU/IO module 1
DISK ACCESS LED
DUMP (NMI)
switch
FRONT
PRIMARY LED
To install ESXi on internal disk,
only one hard disk drive should
be installed in this slot.
Module POWER LED