1. Setup Procedure
Express5800/R320d-E4, R320d-M4 Installation Guide (VMware 5.5)
Chapter 1 Installing OS
1.5
Disabling OS Boot Monitoring Function
Before starting system start up, the OS boot monitoring function needs to be disabled.
Important Be sure to disable boot monitoring function before setting up the system.
This server has a function to monitor the server at startup. (Enabled in the
configuration at shipment)
If this function is enabled, the system will be forcibly restarted while OS setup
screen is shown and the setup will be unsuccessful. BIOS may repeat OS setup in an
invalid manner.
If setup fails, you must re-install the operating system.
Tips For details of operations for BIOS Setup Utility and parameters for boot monitoring
function, refer to Chapter 3 (1. System BIOS) in Maintenance Guide.
1. When you move the cursor onto "Server", the Server menu appears.
Move the cursor onto "OS Boot Monitoring" and press Enter.
Parameters will be displayed.
2. Among the parameters, choose "Disabled" and press Enter.
The current display of the configuration for OS Boot Monitoring will be changed to "Disabled".
To Next Page
Loading...
Need help?
General