1. Setup Procedure
Express5800/R320d-E4, R320d-M4 Installation Guide (VMware 5.5)
Chapter 1 Installing OS
3. Move the cursor onto Save & Exit, the Save & Exit menu appears.
4. Select Save Changes and Exit.
On the confirmation window shown below, select [Yes] to save parameters and exit SETUP.
Now OS Boot Monitoring function is disabled.
System reboots when SETUP completes.
Tips When installing ESXi, power off the server for preparation of installation.
To continue with the setup procedure, proceed to “1.6 Setting HBA configuration by using
QLogic” on the next page if the FC card is enabled, and to “1.7 Installing VMware ESXi” if
the internal disk is enabled.
To Next Page
Loading...
