NEC Express 5800 Series - Procedures after Completion of Installation; Confirmation of the Kernel Version

2. Procedures after Completion of Installation
Express5800/R320d-E4, R320d-M4 Installation Guide (VMware 5.5)
63
Chapter 1 Installing OS
2.
Procedures after Completion of Installation
2.1
Confirmation of the Kernel Version
Explain how to check the kernel version of ftSys Management Appliance and a version of VMware ESXi.
Check the version following the steps below.
VMware ESXi
1. Run the following command on the ftSys Management Appliance.
Make sure that Version, Build, and Update are exactly same as those shown above.
Note The "Build" column shows the number given after the patch program was applied.
ftSys Management Appliance
1. Run the following command on the ftSys Management Appliance.
"2.6.18-274.e15" indicates version of kernel, and "#1 SMP Fri Jul 22 04:43:29 EDT 2011" indicates
release information of kernel.
Make sure that the version of kernel is correct.
This completes version confirmation.
# uname –a
Linux ftsysMgt-Cygnus 2.6.18-
274.el5 #1 SMP Fri Jul 22
04:43:29 EDT 2011 x86_64 x86_64 x86_64 GNU/Linux
# esxcli –s <
IP address of ESXi host
> system version get
Product: VMware ESXi
Version: 5.5.0
Build: Releasebuild-1746018
Update: 1