NEC Express 5800 Series - Changing the Firewall Rules on Ftsys Management Appliance

2. Procedures after Completion of Installation
Express5800/R320d-E4, R320d-M4 Installation Guide (VMware 5.5)
66
Chapter 1 Installing OS
2.3.3
Changing the Firewall Rules on ftSys Management Appliance
Default Firewall Rules
The default firewall rules after the setup are as follows.
Input/Output
Destination
Port
Source Port Protocol Service
Input
514
67-68
udp
syslogd
*
1
Input 22 * tcp ssh
Input
67-68
67-68
udp
bootp
Input 80 * tcp http
Input
161
*
*
SNMP
Input 443 * tcp https
Input
3052
*
*
APC
Input 5480 * tcp VAMI
Input 6547 * tcp APC
Input 8089 * tcp Apache/ftWeb
Input 8090 * tcp OSM
CIM-Indications
Output 22 * tcp ssh
Output
23
*
tcp
telnet
Output 53 1024-65535 * DNS
Output
67-68
67-68
udp
bootp
Output 80 * tcp http
Output
162
*
*
snmp-trap
Output 443 * tcp https
Output
5989
*
tcp
sfcbd/https
Output * 3052 * APC
*1. When the log server is configured on ftSys Management Appliance
Use the report method except the Manager Report (SNMP), change the setting of the firewall. NEC ESMPRO
Agent (in the table referred to as Agent) list of port to use when the report is the following.
"Direction" in the table include the bi-directional arrows in the top row is at the starting time of the
communication, and the lower shows the communication of return.
Function in (Agent) Direction Out (default) Note
Manager Report (SNMP)
Auto → 162/udp
Port opening
(default)
Manager Report (TCP/IP)
Auto
→
←
31134/tcp
Via the Manager
Express Report Service
Auto
→
←
31136/tcp
HTTPS (Via the Manager)
Express Report Service
Auto
→
←
31138/tcp
Express Report Service
(Internet email)
Auto
→
←
25/tcp
smtp
→
←
110/tcp
pop3
Express Report Service
(HTTPS)
Auto
→
←
443/tcp
https Port opening
(default)