1. Setup Procedure
Express5800/R320d-E4, R320d-M4 Installation Guide (VMware 5.5)
Chapter 1 Installing OS
1.6
Setting HBA configuration by using QLogic
Important Before setting the HBA configuration by using QLogic BIOS, it is required to
complete the storage settings such as creating a logical disk.
1. Start from the CPU/IO module 0, and then perform the following.
Important Make sure that the PRIMARY LED on CPU/IO module 0 is lit.
1-1 In the QLogic prompt window which appears during POST, press Ctrl+Q or Alt+Q to launch
QLogic Fast! UTIL.
1-2
Select “Configuration Settings”, and then press Enter.
To Next Page
Loading...
