NEC Express 5800 Series - Confirmation of the Ft Control Software Version

2. Procedures after Completion of Installation
Express5800/R320d-E4, R320d-M4 Installation Guide (VMware 5.5)
64
Chapter 1 Installing OS
2.2
Confirmation of the ft control software Version
The following describes how to check the version of ft control software.
Confirm the version following the steps below:
Note Running the following command may fail
if the necessary process does not run
immediately after the system startup. In this case, wait for a while (several minutes or so),
and try again.
1. Run the following command on the ftSys Management Appliance.
The version of the ft control software in operation is displayed.
Make sure that the version is exactly same as that shown above.
This completes the version confirmation.
# /opt/ft/bin/ftsmaint –v
ftsys-ftsmaint version 5.1.1-233