1. Bundled Software for the Server
Express5800/R320d-E4, R320d-M4 Installation Guide (VMware 5.5)
Chapter 2 Installing Bundled Software
1.1.2
Install NEC ESMPRO Agent
Connect to the ESXi host from vSphere Client to configure.
Important
Be sure to connect to the ESXi host from vSphere Client.
Do not connect to the vCenter Server.
1. Set the ft control software Install DVD to the DVD drive of the machine where vSphere Client is
installed.
2. Select the ftSys Management Appliance in the left pane of vSphere Client, and click the CD/DVD
button on toolbar to connect with the DVD drive that contains ft control software Install DVD.
3. Log in to ftSys Management Appliance as a root user.
4. Mount the ft control software Install DVD. When /mnt/cdrom directory exists, the making of the
directory is unnecessary by mkdir command.
# mkdir /mnt/cdrom
# mount /dev/cdrom /mnt/cdrom
5. Run the following command to change the directory that contains NEC ESMPRO Agent.
# cd /mnt/cdrom/NEC/esmpro-sa/
6. Run the following command to install the NEC ESMPRO Agent.
# rpm -ivh Esmpro-*
7. Run the following command to change setting of ESMstrg.
# /sbin/chkconfig ESMstrg off
8. Running the following command displays the messages as shown below.
# cd /opt/nec/esmpro_sa/tools
# ./sethwinf
Enter the number and set the system information.
1. Product Name: Other
2. Product Manufacturer: Other
3. Chassis Type: Other
s. Save and quit
q. Quit without save
Please input your selection (1 to 3, s, q):
Examples)
1. Product Name: NEC Express5800/R320d-M4
2. Product Manufacturer: NEC
3. Chassis Type: Rack
9. Change directory, and unmount the ft control software Install DVD.
# cd /
# umount /mnt/cdrom
To Next Page
Loading...
Need help?
General