Overview 6
GUI, CLI, and Scripting interfaces are available.
English, Japanese are supported.
Applications can be executed using the following tools:
o All server platform host operating systems supported with server(For a list of supported operating
systems, see a product page of server in the NEC Corporate Website (http://www.nec.com/))
o EXPRESSBUILDER
All formats can run in both online and offline environments.
The utility can run on any machine that uses a supported browser.
Support for configuration tasks
SSA supports the configuration tasks listed below. Support for individual tasks varies according to your
controller type. You should always have the latest firmware installed so that you have access to all of the
features supported for your controller.
About the features your controller is supporting, see controller user guide.
Assign a RAID level to a logical drive
Assign spare drives to an array
Configure multiple systems identically
Copy the configuration of one system to multiple systems
Create multiple logical drives per array
Create or delete arrays and logical drives
Enable or disable a physical drive write cache
Expand an array
Extend a logical drive
Heal an array
Identify devices by causing their LEDs to flash
Migrate the RAID level or stripe size
Move an array (copy all array data to a new array and then delete the old array)
Move and delete individual LUNs
Re-enable a failed logical drive
Set the boot controller
Set the expand priority, migrate priority, and accelerator ratio
Set the spare activation mode
Set the stripe size
Set the surface scan delay
Share a spare drive among several arrays
Remove a drive from an array (restripe the data on an array to occupy fewer physical drives, then
remove the excess drives from the array)
Specify the size of the logical drive
Split a RAID 1 array or recombine a split array (offline only)
To Next Page
Loading...
Need help?
General