SSA Scripting 91
SSA scripting warning messages
License key is already installed
The input file specified a license key. However, a
license key is already installed on the controller.
Clear configuration command failed -
configuration is already cleared
The -reset option was used on a controller that
does not have a configuration.
Chassis name is already set to this value
The chassis name is already set to the supplied
value. The command is ignored.
One or more controller commands were
skipped because the controller is not
configured
Certain commands require that the controller be
configured before they can be sent to the
controller.
Some commands have been ignored because the
Repeat parameter has been specified in the input
file.
The system must be rebooted for the
firmware flash to complete
A controller has been flashed with new firmware.
The new firmware requires a reboot to take effect.
Unable to set the array accelerator for this
volume. The cache board may be missing or
have a bad status, or the controller may not
support a cache
The controller may not support a cache (for
example, some Software RAID controllers) or the
cache may be missing or defective.
The controller does not have a battery
attached
The operation requested requires a battery and one
was not attached.
The controller battery status is Failed
The operation requires a battery and the attached
battery has failed.
This parameter cannot be modified
The input script attempted to modify a parameter
which is not modifiable.
Rapid Parity Initialization is not available
Rapid Parity Initialization is not available on the
selected volume; there may already be an RPI in
progress, or the firmware does not support RPI.
The command is not available when
MODE=CONFIG
The command is not availbale when
MODE=RECONFIG
SSA scripting error messages
No error exists. The program completed successfully.
Too many coinciding expansion, migration,
or extension operations
The new configuration requires more
transformations than are possible at one time. For
example, you cannot expand a logical volume and
transform its RAID level at the same time.
Controller does not support license keys
The controller does not support license key entry or
deletion.
The entered license key is not a valid license key.
Controller does not support SSP
The controller does not support SSP functions.
The requested actions are invalid, for example,
combining -reset with capture mode.
The method must be either Custom or Auto.
An invalid controller value was specified.
No controllers were detected. This error applies to
To Next Page
Loading...
Need help?
General