English-14
Mounting (for customer)
WARNING:
DO NOT mount the monitor yourself. This device cannot
be used or installed without a mounting accessory for
support. For proper installation, it is strongly recommended
to use a trained, qualied technician. Failure to follow NEC
standard mounting procedures could result in damage to
the equipment or injury to you. Please contact your supplier
as they may be able to provide a list of qualied installation
professionals. Mounting on a wall or ceiling and hiring a
technician is the customer’s responsibility.
Maintenance
• Periodically check for loose screws, gaps, distortions,
or other problems that may occur with the mounting
equipment. If a problem is detected, please refer to
qualied personnel for service.
• Regularly check the mounting location for signs of damage
or weakness that may occur over time.
DO NOT block ventilated openings with mounting
accessories or other accessories.
Mounting (for NEC qualied personnel)
Stability Hazard.
The device may fall, causing serious personal injury or death.
To prevent injury, this device must be securely attached to
the oor/wall in accordance with the installation instructions.
Carefully inspect the location where the unit is to be
mounted. Not all walls or ceilings are capable of supporting
the weight of the unit. Weight of this monitor is mentioned in
the Specication (see page 38).
Product warranty does not cover damage caused by
improper installation, re-modeling, or natural disasters.
Failure to comply with these recommendations could result in
voiding the warranty.
To ensure safe installation, use two or more brackets to
mount the unit. Mount the unit to at least two points on the
installation location.
WARNING:
Failure to follow NEC standard mounting procedures could
result in damage to the equipment or injury to the user or
installer.
Please note the following when mounting on wall or ceiling
• NEC recommends mounting interfaces that comply with
UL1678 standard in North America.
• NEC strongly recommends using size M8 screw
(18-20 mm + thickness of bracket and washers in length).
If using screws longer than 18-20 mm, check the depth of
the hole. (Recommended Fasten Force:1000 - 1200N•cm).
• Prior to mounting, inspect the installation location to
ensure that it is strong enough to support the weight of the
unit so that the unit will be safe from harm.
• For detailed information, refer to the instructions included
with the mounting equipment.
• Make sure that there is no gap between the monitor and
the bracket.
Screw
Unit
18-20 mm
Thickness of bracket
and washers
No gap
Washers
Mounting Bracket
No thread 2 mm
Installing a safety wire
CAUTION:
The monitor may fall causing damage to the monitor or
personal injury. To prevent the monitor from falling off from
the wall or ceiling, NEC strongly recommends using a safety
wire.
• Do not attempt to hang the monitor using an installation
safety wire. The monitor must be properly installed.
• Please install the monitor in a spot of the wall or ceiling
strong enough to support the monitor.
• To prevent the monitor from falling off from the wall or
ceiling, NEC strongly recommends using a safety wire.
• Prepare the monitor using mounting accessories such
as hook, eyebolt or mounting parts and then secure the
monitor with a safety wire. The safety wire must not be
tight.
• Please make sure the mounting accessories are strong
enough to support the monitor before mounting it.
To Next Page
Loading...
Need help?
General