NEC MultiSync WD551 User Manual

English-29
English
OSD Settings
Advanced Setting
Menu Function
Data & Time Network Time
Set the time manually.
Get time automatically from network.
Data Set the year, month, and day. (YYYY, MM, DD)
Time Set the current time.
Time Zone Select the local time zone to use the monitor.
Customer NTP Server Optionally congure this setting to synchronize with an NTP server on the network to set
the current date and time. It can be set by IP address or host name.
NETWORK*
1
DHCP Congure the network settings manually. Contact the Network Administrator for
this information.
The IP address is automatically obtained from the DHCP server.
IP Address
Set the IP address for the monitor connected to the network when
is selected for
[DHCP].
Subnet Mask
Set the subnet mask data for the monitor connected to the network when
is
selected for [DHCP].
Default Gateway
Set the default gateway for the monitor connected to the network when
is selected
for [DHCP].
Auto DNS
Manually enter the IP address of the DNS server which is connected to the
monitor.
The DNS server which is connected to the monitor will automatically assign its
IP address.
DNS Enter the DNS server settings of the network connected to the monitor.
MAC Address Shows the monitor’s [MAC Address].
Apply Apply the network settings.
Power Auto Power ON Signal Detected
The monitor does not automatically turn on when a signal
is input.
The monitor turns on automatically when a signal is input.
Presence Sensor
The monitor does not turn on automatically even if a
person is detected by the motion sensor.
The monitor automatically turns on when a person is
detected by the motion sensor.
AUTO STANDBY Off Maintain Power ON state.
5, 15, 30 Minutes If there is no signal for the set time, the device shifts to the Screen
off*.
* In WCD Mode. It shifts to the standby status in Standard Mode.
Cloud Settings*
2
Cloud Service Enable Enables the cloud connection and transmits telemetry data.
Telemetry data is the sensor environment data described on
page 10.
Disable Disables the cloud connection.
Telemetry data
transmission interval
Sets the time between telemetry data transmission to your servers. The interval can be
set between 10 to 120 minutes in 10-minute increments.

NEC MultiSync WD551 Specifications

General

Brand	NEC
Model	MultiSync WD551
Category	Monitor
Language	English